Underground Tank Sensor Installation

Some underground tank monitors have a valve in the way of the slot on the R3D dial, so you'll need to remove your dial, attach your monitor's sensor to the dial, and then add the dial back to the tank gauge. 

DO NOT loosen the 4 large bolts at the corners of the gauge head

  1. Remove the dial from your tank, by taking out only the 2 small screws.

2. Slide the sensor on the monitor (the little black piece at the end of the cable that looks like a boot) into the dial. 

3.  Attach the dial (with sensor attached) to the tank with the 2 small screws. Make sure it's in the same orientation as it was previously.

Still need help? Contact our Support Team Contact our Support Team